cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements
6514
Views
0
Helpful
8
Replies
Highlighted
Beginner

how to reset stacked switches to factory default

Hello All,

I have 2 stacked Catalyst 2906s switches, how to reset them to factory default simultaneously?

thanks. 

1 ACCEPTED SOLUTION

Accepted Solutions
Highlighted
Hall of Fame Community Legend

I found that stack is still working..  

Of course it's still working.  The stacking cable is still connecting both units.

View solution in original post

8 REPLIES 8
Highlighted
Hall of Fame Community Legend

Use the command "wr erase" and check for the presence of "config.text" and "vlan.dat" files.  If the files are no longer present, reboot.  

Highlighted

i used command "write erase" and also deleted ''vlan.dat",

but after "reload", the stack is still working...

Highlighted
Hall of Fame Community Legend

the stack is still working...

What do you mean "stack still working"?  Was the stacking cable removed or not?

Highlighted

I didn't remove the stacking cable, but I powered off one switch (A), the powered on the other switch (B), after rebooting, I powered on the switch B, I found that stack is still working..  

Highlighted
Hall of Fame Community Legend

I found that stack is still working..  

Of course it's still working.  The stacking cable is still connecting both units.

View solution in original post

Highlighted

Got it.

Thank you very much.

Highlighted
Beginner

#switch clear stack-mode

Highlighted

does this mean that the switch is unstacked? 

 

H/W Current
Switch# Role Mac Address Priority Version State
----------------------------------------------------------
*1 Master b0fa.ebfa.ac00 5 1 Ready

Content for Community-Ad