08-15-2017 07:54 PM - edited 03-08-2019 11:45 AM
Hello All,
I have 2 stacked Catalyst 2906s switches, how to reset them to factory default simultaneously?
thanks.
Solved! Go to Solution.
08-16-2017 08:08 PM
I found that stack is still working..
Of course it's still working. The stacking cable is still connecting both units.
08-15-2017 08:01 PM
Use the command "wr erase" and check for the presence of "config.text" and "vlan.dat" files. If the files are no longer present, reboot.
08-15-2017 08:23 PM
i used command "write erase" and also deleted ''vlan.dat",
but after "reload", the stack is still working...
08-15-2017 10:19 PM
the stack is still working...
What do you mean "stack still working"? Was the stacking cable removed or not?
08-16-2017 07:44 PM
I didn't remove the stacking cable, but I powered off one switch (A), the powered on the other switch (B), after rebooting, I powered on the switch B, I found that stack is still working..
08-16-2017 08:08 PM
I found that stack is still working..
Of course it's still working. The stacking cable is still connecting both units.
08-16-2017 09:03 PM
Got it.
Thank you very much.
08-13-2019 05:24 AM
#switch clear stack-mode
08-19-2019 10:05 AM
does this mean that the switch is unstacked?
H/W Current
Switch# Role Mac Address Priority Version State
----------------------------------------------------------
*1 Master b0fa.ebfa.ac00 5 1 Ready
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide