10-19-2013 09:14 PM - edited 03-07-2019 04:07 PM
Hi,
I want to know the present aging time of the below switch. And also the default againg time for a layer 2 2960 switch.
FYI: I'm using PT.
switch2#show mac-address-table ?
dynamic dynamic entry type
interfaces interface entry type
static static entry type
<cr>
Regards,
Chandu
Solved! Go to Solution.
10-19-2013 09:39 PM
Hi,
Try this command on your switches:
sw1#sh mac address-table agi
sw1#sh mac address-table aging-time
Global Aging Time: 300
Vlan Aging Time
---- ----------
sw1# sw1#sh mac address-table agi
sw1#sh mac address-table aging-time
Global Aging Time: 300
Vlan Aging Time
---- ----------
sw1#
HTH
10-19-2013 09:39 PM
Hi,
Try this command on your switches:
sw1#sh mac address-table agi
sw1#sh mac address-table aging-time
Global Aging Time: 300
Vlan Aging Time
---- ----------
sw1# sw1#sh mac address-table agi
sw1#sh mac address-table aging-time
Global Aging Time: 300
Vlan Aging Time
---- ----------
sw1#
HTH
10-19-2013 10:27 PM
Thanks for you help. But may be it is not available in PT.
switch1#show mac-address-table aging-time
^
% Invalid input detected at '^' marker.
Regards,
Chandu
10-20-2013 08:14 AM
Hi,
You are trying:
switch1#show mac-address-table aging-time
try this:
sh mac address-table agi
no dash between mac and address
HTH
10-20-2013 11:25 PM
Hi Sharifi,
Still same.
switch1#sh mac address-table agi
^
% Invalid input detected at '^' marker.
switch1#
Regards,
Chandu
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: