cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
426
Views
0
Helpful
1
Replies

How to Tag Native Vlan?

tim.zhao
Beginner
Beginner

Hi everyone,

 

I have a C2960x running 15.2(2)E7 .

 

I know in the pass version using command "vlan dot1q tag native" or "switchport trunk native vlan tag" to tag native vlan.

 

But I can't find such command in version 15.x

 

C2960X(config)#vlan ?
WORD ISL VLAN IDs 1-4094
access-map Create vlan access-map or enter vlan access-map command mode
configuration vlan feature configuration mode
filter Apply a VLAN Map
group Create a vlan group
internal internal VLAN

 

C2960X(config-if)#switchport trunk native vlan 1 ?
<cr>

C2960X(config-if)#switchport trunk native vlan ?
<1-4094> VLAN ID of the native VLAN when this port is in trunking mode

 

So how can I tag the native vlan in version 15.x?

 

Thank you for any answers.

 

Best Regards,

Tim

1 Accepted Solution

Accepted Solutions

marce1000
VIP Mentor VIP Mentor
VIP Mentor

 

 - The command is not supported on switched using the LAN base feature set.

 M.

View solution in original post

1 Reply 1

marce1000
VIP Mentor VIP Mentor
VIP Mentor

 

 - The command is not supported on switched using the LAN base feature set.

 M.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers