cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1178
Views
0
Helpful
2
Replies

interface reset

krjohnson
Level 1
Level 1

I have an ISR with and interface that shows up as follows;

GigabitEthernet0/0 is reset, line protocol is down

I cannot get rid of the 'reset' state... actually I'm not quite sure what 'g0/0 is reset' really means, I don't recall having ever seen this statement before. Can someone enlighten me?

thanks

kj

2 Replies 2

Shashank Singh
Cisco Employee
Cisco Employee

Hi,

The interface status is incorrectly displayed as reset. This is due to an internal cosmetic bug which has been fixed in IOS version 15.0(1)M4 and later.

Cheers,

Shashank

P.S. Please rate if this helped answer your question.

Hi,

Please find the below will help you.

Serial x is down, line protocol is down This status indicates that the router is not sensing a carrier detect (CD) signal.

Possible Causes:
  1. Telephone company problem.
  2. Faulty or incorrect cabling
  3. Hardware failure

Suggested Actions:

  1. Check the LED's on the CSU/DSU to see if the CD light is active.
  2. Verify that the cables are connected properly.
  3. Reset your equipment
  4. Contact your leased-line provider
  5. Replace faulty equipment

Please rate the helpfull posts.

Regards,

Naidu.