I would like to ask for help if anyone knows about network configuration.
Interface vlan is set as below picture.
Although they are different networks, pc1 and pc2 are communicating.
As I understand it shouldn't be able to communicate, what am I missing?
Go to Solution.
Is routing enabled on your L3 switch? If so, L3 switch will route between directly connected networks.
View solution in original post
share output of #show ip rout
also enable routing using #ip routing
On some models of L3 switches routing is disabled by default; enable it with ip routing or ip routing enable command.
Regards, ML**Please Rate All Helpful Responses **
if this is GNS3, then try other L3SW image, some image have bug. your config is OK.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: