IOS Image Boot Sequence

[kamrannaseem]

Hi All,

I am using cisco 3750G switch i have got two images in flash, I want to make second image as my defeult boot image, how do i do that ?

Any help will be much appriciated.

Many thanks,

Kamran.

[Ivan Shirshin]

:-)

[kamrannaseem]

Hi,

Thank you ever so much guys it is working !!!!!!

much appriciated for your time.

Many thanks.

Kamran.

[Ivan Shirshin]

welcome, Kamran!

[sanjoy74p]

Hi Ivan ,

I am using C-2960X series switch on my production environment .

I have uploaded the following image from tftp c2960x-universalk9-mz.152-7.E9.bin on the switch and made the boot sequence done by executing following commands .

boot-start-marker
boot system flash:c2960x-universalk9-mz.152-7.E9.bin >> New uploaded image 
boot system flash:c2960x-universalk9-mz.152-7.E7.bin  >>> Existing Image 
boot-end-marker

But when i see the running config there is no boot sequence present as above . for other device like ISR router i can see boot sequencing is working as expected .

[sanjoy74p]

I am using C-2960X series switch on my production environment .

I have uploaded the following image from tftp c2960x-universalk9-mz.152-7.E9.bin on the switch and made the boot sequence done by executing following commands .

boot-start-marker
boot system flash:c2960x-universalk9-mz.152-7.E9.bin >> New uploaded image 
boot system flash:c2960x-universalk9-mz.152-7.E7.bin  >>> Existing Image 
boot-end-marker

But when i see the running config there is no boot sequence present as above . for other device like ISR router i can see boot sequencing is working as expected .