IR809 IOS upgrade failure

[r.shummoogum]

Hello:

appreciate any help on the error below

Thanks

IR809-LAB#bundle install flash:ir800-universalk9-bundle.SPA.156-3.M.bin

Installing bundle image: /ir800-universalk9-bundle.SPA.156-3.M.bin.........................................................................................................

updating Hypervisor image...

%Error copy from scp://*:*@127.1.3.1//vds_system/bundle/ir800-hv.srp.SPA.2.5.7 to bootstrap:ir800-hv.srp.SPA.2.5.7

Failed to install hypervisor image!

[Harsha A.]

Hello r.shummoogum,

Are you copying this .bin file from a SCP server to the bootstrap: ? 

Regards,

Harsha

[r.shummoogum]

Downloaded the file from the Cisco web site to my PC (with Chrome).

Then TFTP the file from my PC (using 3CDaemon) to the IR809.

[r.shummoogum]

problem solved

Enabling ssh on the Loopback0 interface causes the bundle install to fail.

[Niklas.D]

Hey Mark this as "solved" as this also solved it for me ;) 

kudos bro

[Bob_Rock]

Hi, 

I have the same issue with IR829, could you please tell what do you mean with "Enabling ssh on the Loopback0 interface causes the bundle install to fail", I dont have ip ssh source-interface loopback 0 or something like that in my configuration.

Thank you

[Niklas.D]

Hi bob, do you mind posting your config?

the command i hade was this:

ip ssh source-interface GigabitEthernet0.2

when i removed it everything started to work

but if you dont use that i think we need to look at the config!