05-24-2022 10:49 AM
I have the following config on both my Nexus primary and my Nexus secondary:
interface port-channel310
description Dell TOR 1
switchport
switchport mode trunk
switchport trunk native vlan 599
switchport trunk allowed vlan 551-560
vpc 310
interface port-channel311
description Dell TOR 2
switchport
switchport mode trunk
switchport trunk native vlan 599
switchport trunk allowed vlan 551-560
vpc 311
interface Ethernet1/45
description UPLINK to Dell TOR 1
switchport
switchport mode trunk
switchport trunk native vlan 599
switchport trunk allowed vlan 551-560
channel-group 310 mode active
interface Ethernet1/47
description UPLINK to Dell TOR 2
switchport
switchport mode trunk
switchport trunk native vlan 599
switchport trunk allowed vlan 551-560
channel-group 311 mode active
This is to connect to a pair of Dell switches a 3rd party is using, the Dell's are set up just like my Nexus vpc pair, which i believe the correct Dell term is VLT.
the vendor is asking for one port channel....can i assign all 4 Nexus ports to VPC 310?
Solved! Go to Solution.
05-24-2022 10:55 AM - edited 05-24-2022 10:57 AM
the vendor is asking for one port channel....can i assign all 4 Nexus ports to VPC 310?
Yes, simply put all 4 physical ports in one portchannel, and make sure all vlans are part of the vPC peer-link
HTH
05-24-2022 10:55 AM - edited 05-24-2022 10:57 AM
the vendor is asking for one port channel....can i assign all 4 Nexus ports to VPC 310?
Yes, simply put all 4 physical ports in one portchannel, and make sure all vlans are part of the vPC peer-link
HTH
05-24-2022 11:02 AM - edited 05-24-2022 11:03 AM
why not,
PO (all port are members) from NSK-1 have vPC 100 <-exmaple
PO (all port are members) from NSK-2 have vPC 100
since these PO have same VLAN then Yes you can.
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: