Linecard temperature

[b.withrow]

Hello all!

Wondering if anyone knows of a command that will tell the temperature of a linecard in a Cisco 10012 router. If not, I assume I could get it via SNMP. Does anyone know of an OID that would supply that information? Thanks in advance!

[sourabhagarwal]

"show environment" command is used to check the internal system status. The environmental monitor continually checks the interior chassis environment; it provides warnings for high temperature and creates reports on any occurrences.

Also check if "show power module " command works in this router which can give power status of specific module.

rate if it helps ...

[b.withrow]

Show env only show's the input and output temperature. I am seeing a big difference between the two, so I wondering where the heat is coming from. SO I wanted to see the temp on each card individually.

I just tried show power-mod and that did not work, but thanks for the suggestion.

[sourabhagarwal]

can you try using show environment command with options.

check this URL to see what all options are available.

http://www.cisco.com/univercd/cc/td/doc/product/software/ios112/ios112p/gsr/c12012.htm#xtocid2972734

check this URL to see if you can get the information through SNMP.

http://www.cisco.com/en/US/products/hw/routers/ps133/products_mib_quick_reference_chapter09186a0080781160.html

rate if it helps ....

[dan-jones]

OID is here:

http://tools.cisco.com/Support/SNMP/do/BrowseOID.do?objectInput=cevSensor&translate=Translate&submitValue=SUBMIT&submitClicked=true