03-25-2011 04:29 AM - edited 03-06-2019 04:15 PM
Hi,
On a 3750 running 12.2(55) is there a command or a series of commands that will let me see which ip addresses are seen on each port?
sh ip arp just shows the vlan ip addresses are seen from, but I need to correlate ip addresses to port numbers for directly connected hosts.
Any help surely is appreciated. Thanks.
Also what commands are needed to turn on snmp so a switch port mapper application can provide this information?
Solved! Go to Solution.
03-25-2011 05:19 AM
You need to us the mac-addresses ie. show the mac-address table which will show the mac to port mapping and then use arp to match the mac-address to the IP.
Note if the 3750 is acting as L3 switch this will work fine. If it is a L2 switch then you need to look at the arp table on the L3 device responsible for the inter-vlan routing.
Jon
03-25-2011 05:19 AM
You need to us the mac-addresses ie. show the mac-address table which will show the mac to port mapping and then use arp to match the mac-address to the IP.
Note if the 3750 is acting as L3 switch this will work fine. If it is a L2 switch then you need to look at the arp table on the L3 device responsible for the inter-vlan routing.
Jon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide