Manual Allocation of dsp in router
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-05-2010 07:35 PM - edited 03-06-2019 10:28 AM
Hi
Can I do a manual allocation of the dsp resources in router?
1. If I have 3 PVDM, can I assign one PVDM solely for conference, one PVDM solely for transcoding?
2. Can I sub-divide a PVDM to split across differently functionalities, eg. conferencing use 1dsp, transcoding use another 1dsp out of the same PVDM?
My understanding is dsp is "automatically" assigned across the functionalities, like E1, conferencing, transcoding.
Please correct me if I am wrong.
Thanks
- Labels:
-
Other Switching

- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-06-2010 12:15 AM
Hi
Can I do a manual allocation of the dsp resources in router?
1. If I have 3 PVDM, can I assign one PVDM solely for conference, one PVDM solely for transcoding?
2. Can I sub-divide a PVDM to split across differently functionalities, eg. conferencing use 1dsp, transcoding use another 1dsp out of the same PVDM?
My understanding is dsp is "automatically" assigned across the functionalities, like E1, conferencing, transcoding.
Please correct me if I am wrong.
Thanks
Hi,
Check out the below link hope that helps
http://www.cisco.com/en/US/docs/ios/12_3/vvf_c/interop/intcnf2.html#wp1003287
Ganesh.H
Remeber to rate the helpful post
