cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
7649
Views
5
Helpful
2
Replies

Monitoring Catalyst 3560 health using MIB/SNMP

afeldmar123
Level 1
Level 1

Hi all

I'm a C# programmer and as part of my software I need to monitor some Cisco Catalyst 3560V2 24 switches using SNMP (By reading MIB/S data).
Apparently this switch supports more than 50 different MIBs.
My question is which MIB/MIBS contains general health data (parameters) that may help me to determine if the switch is OK, Degraded or Malfunctioned.

1 Accepted Solution

Accepted Solutions

Hi,

  It depends on what you're going to monitor that switch. Let's check MIBs supported by Cisco 3560.

  Ref:  http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml

  Go to Cisco LAN Switches => Catalyst 3560

  You might want to monitor Temperature , CPU and Memory, You can go for CISCO-ENVMON-MIB , CISCO-PROCESS-MIB.

HTH,

Toshi

View solution in original post

2 Replies 2

Hi,

  It depends on what you're going to monitor that switch. Let's check MIBs supported by Cisco 3560.

  Ref:  http://www.cisco.com/public/sw-center/netmgmt/cmtk/mibs.shtml

  Go to Cisco LAN Switches => Catalyst 3560

  You might want to monitor Temperature , CPU and Memory, You can go for CISCO-ENVMON-MIB , CISCO-PROCESS-MIB.

HTH,

Toshi

10X Toshi!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card