Hello, is there any way to set this in Packet tracer.
I have been using the standard 'ip nat translation timeout' command but it does not work.
Thanks for any help.
hi philip,
PT device IOS capabilities are limited. try using GNS3 (or real gear) instead.
thank you for your help.
So is that a confirmation that this command or a variation on it is not available in Packet Tracer ?
Thanks,.
hi philip,
what options do you get in PT when you issue this command under global config mode?
ip nat translation ?
i've removed PT on my PC so i can't confirm right now.
I can only get as far as:
Belfast(config)#ip nat ?
inside Inside address translation
outside Outside address translation
pool Define pool of addresses
Belfast(config)#ip nat
Thanks.
Hi Philip,
I'm sorry to say the command isn't an option or available due to PT/IOS's constraint.
Sent from Cisco Technical Support iPhone App