NAT translation timeout in Packet Tracer ?

[fran19422]

Hello, is there any way to set this in Packet tracer.

I have been using the standard 'ip nat translation timeout' command but it does not work.

Thanks for any help.

[johnlloyd_13]

hi philip,

PT device IOS capabilities are limited. try using GNS3 (or real gear) instead.

[fran19422]

thank you for your help.

So is that a confirmation that this command or a variation on it is not available in Packet Tracer ?

Thanks,.

[johnlloyd_13]

hi philip,

what options do you get in PT when you issue this command under global config mode?

ip nat translation ?

i've removed PT on my PC so i can't confirm right now.

[fran19422]

I can only get as far as:

Belfast(config)#ip nat ?

  inside   Inside address translation

  outside  Outside address translation

  pool     Define pool of addresses

Belfast(config)#ip nat

Thanks.

[johnlloyd_13]

Hi Philip,

I'm sorry to say the command isn't an option or available due to PT/IOS's constraint.

Sent from Cisco Technical Support iPhone App