12-30-2008 05:28 AM - edited 03-06-2019 03:11 AM
I have a 3750 at a remote location. I have it connected to an Avocent console server, so I can access it via the console. It currently has no image on it and only loads to the boot loader.
I know that typically I could load an image through xmodem, but I don't think I have that as an option with the console server.
I have the switch connected to another 3750 with a stack cable. Is there a way that I can push the image through this?
Or does anyone know how I can use xmodem with the Avocent?
Thanks.
Jason
12-30-2008 06:17 AM
Jason-
If you ever figure out how to xmodem via the Avocents, please post it. We use them too and I have not figured that out yet. On to your issue. If you type dir all, you should see the file systems for all the switches in the stack. Then copy from one file system to another.
copy flash3:/c3750-ipservicesk9-mz.122-35.SE2.bin flash1:/c3750-ipservicesk9-mz.122-35.SE2.bin
Hope that helps.
12-30-2008 06:19 AM
Since the bad switch will only load into the boot loader, the good switch in the stack is not seeing it as a member.
12-30-2008 06:22 AM
Yup you're right, sorry about that. Have you tried the auto-upgrade command? Here's a link on it and other troubleshooting tips.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide