01-13-2020 09:08 PM
SW6509#sh run int gi/32
Building configuration...
Current configuration : 382 bytes
!
interface GigabitEthernet8/33
description description TEST_ENV
switchport
switchport access vlan 215
switchport trunk encapsulation dot1q
switchport trunk allowed vlan 205,217
switchport mode access
no ip address
speed 100
duplex full
no snmp trap link-status
spanning-tree portfast
spanning-tree bpduguard disable
spanning-tree guard root
end
SW6509#
Solved! Go to Solution.
01-14-2020 12:31 AM
Hi,
As per your configuration, it seems like that this port was configured as Trunk but a letter on you had changed it on the Access mode.
When you will change the mode of a switch port from trunk to access or vise Versa. It will not remove the old commands. You have to remove manually. Currently, this port is working as Administrative Mode: static access and access VLAN is 215.
01-13-2020 09:09 PM
01-13-2020 11:53 PM
Hi there,
What config the switchport uses from switchport access ... and swichport trunk ... is determined by the configured switchport mode ... command.
In this case the switchport mode is access so it will be sending frames untagged from VLAN 215 and placing all untagged frames received into VLAN 215.
cheers,
Seb.
01-14-2020 12:31 AM
Hi,
As per your configuration, it seems like that this port was configured as Trunk but a letter on you had changed it on the Access mode.
When you will change the mode of a switch port from trunk to access or vise Versa. It will not remove the old commands. You have to remove manually. Currently, this port is working as Administrative Mode: static access and access VLAN is 215.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide