Hi All,
I'm using Network Assistant to configure 2 3560CG-8PC-S units. I have them trunked together and created the VLANs I need. I have enabled routing, and assigned IP address/SN Mask to all the VLANs. I'm trying to figure out how to assign a VLAN to a physical port on the slave unit (the 3560 that is not performing the routing). The Network Assistant software has a drop-down list on the "VLANs" window, "Configure Ports" tab, but only 1 unit shows up (master unit, by name).
How do I use NA to assign VLANs to physical ports on the slave devices? The topology view indicates that I am connected to the master, but it identifies the slave unit by name.