cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

197
Views
0
Helpful
1
Replies
Highlighted

No CONFIGURE command 2960L

I just picked up two 2960L's (WS-C2960L-SM-8PS) and both of them are experiencing the same issue. 

 

I connected via console port and booted up. Boot process was mostly normal, except for a couple of "%PARSER-4-BADCFG: Unexpected end of configuration file" errors.

 

Boot process finishes, and I can get into privileged mode no problem. Then things get weird.

 

Try to run "conf t" and I return "% Invalid input detected at '^' marker." What? 

 

Hit ? and CONFIGURE is completely missing from the command list. I am attaching output of both the command list as well as the running config.

 

Any ideas? Never had this issue before. I went through the documentation on the 2960, and it clearly states that you should be able to enable and go right to config mode.

 

I found one other discussion on this topic, but no definite resolution.

 

Thanks for your help.

 

 

 

1 REPLY 1

Re: No CONFIGURE command 2960L

Got my answer. Apparently I need to do more research. The SM line is WebUI only. 

 

https://www.cisco.com/c/dam/en/us/products/collateral/switches/catalyst-2960-l-series-switches/q-and-a-c67-737798.pdf

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards