03-11-2021 08:37 PM
i have sg-350 switch i can not connect to my LAN .in switch configure it shows
interface GigabitEthernet34
no switchport
i tried int g34
switchport mode access
switchport access vlan 1
no shut
but it still show in no switchport
all switch port are in vlan 1 there is no configuration of vlan in my switch all configuration isin by default config.no changes are made in switch.
Solved! Go to Solution.
03-25-2021 12:16 AM
finally it works!!! port now in switchport access mode.I tried so many commands and finally this works!!!
int g34
switchport
It works immediately!!
03-12-2021 12:03 AM - edited 03-13-2021 03:21 AM
Hello
First of all make sure the port is set for being a non routed port then try again
int x/x
switchport
03-13-2021 01:00 AM
Can you try to do the same thing through the GUI and check the output in CLI?
03-25-2021 12:16 AM
finally it works!!! port now in switchport access mode.I tried so many commands and finally this works!!!
int g34
switchport
It works immediately!!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide