NTP

[mohammedalrawiib]

Hello everybody 

so i have been assigned to a task from my manager he wants me to activate ntp on a cisco switch (catalyst  9200 ) 

i have all the command line but he keeps telling me you are missing something not on the commands but where to apply this ntp on which interface keep in mind we have a local ntp server on our data center , so what concept am i missing i have been searching for a week but i couldn't actually find anything (i read the whole cisco documents).

thanks in advance   

[Mark Elsen]

             - Post commands tried and the (error) responses you get from the switch , 

 M.

[balaji.bandi · Accepted solution]

Sure you need to post the command

Geneally the config you can define as below :

NTP server config

NTP authentication

NTP using source interface

after you configuration do you have ntp association (show ntp association with your local NTP Server ?)