nx-os command to view all interface input and output rate

[zulfikhar2000]

Is there a way in nx-os where I can view all interface input and output rate, so that I dont have to go each interface & check ?

[Kasun Bandara]

try below

#sh inter | inc rate

[zulfikhar2000]

This doesn’t help…If the switch have 100 ports we can’t trace…

[Joseph W. Doherty]

True, but as MHM added, possibly you just need to further refine your regex.

(PT) e.g.:

Router#sh int | include (is down)|(rate)
GigabitEthernet0/0/0 is administratively down, line protocol is down (disabled)
Queueing strategy: fifo
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
GigabitEthernet0/0/1 is administratively down, line protocol is down (disabled)
Queueing strategy: fifo
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
GigabitEthernet0/0/2 is administratively down, line protocol is down (disabled)
Queueing strategy: fifo
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec
Vlan1 is administratively down, line protocol is down
Queueing strategy: fifo
5 minute input rate 0 bits/sec, 0 packets/sec
5 minute output rate 0 bits/sec, 0 packets/sec

Cisco's regex.

[MHM Cisco World]

I try 
show interface | include input , output, and rate 
all show the rate but the problem not show interface for each line. 
if you dont want interface number then | inlcude is ok if not 
please mention that and I will make deep dive.
thanks  

[thiru.vel10]

Capture the output show interface and filter using Grep tool 

[MHM Cisco World]

 show interface e4/1 , e4/2 | i Ethernet4|rate <<- I found this command try it 
thanks