cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Announcements

2007
Views
0
Helpful
6
Replies
Beginner

PBR is not working

Dear All,

I have created a PBR in 3650 switch to route traffic from a specific IP address to a specific next hop or IP address(Router)

ROM: Bootstrap program is C3560 boot loader

BOOTLDR: C3560 Boot Loader (C3560-HBOOT-M) Version 12.2(44)SE5, RELEASE SOFTWARE (fc1)

SW1 uptime is 6 weeks, 2 days, 16 minutes

System returned to ROM by power-on

System image file is "flash:/c3560-ipservicesk9-mz.150-1.SE2.bin"

access-list 101 permit ip host 192.168.170.92 10.10.10.0 0.0.0.255

route-map MPLS permit 101

match ip address 101

set ip next-hop 192.168.170.4

The next hop router is connected to this switch directly and member of vlan 170,

I am getting the following error

*Apr 13 23:48:25.104: %PLATFORM_PBR-4-SDM_MISMATCH: PBR requires sdm template routing

I also enable "

sdm prefer routing"   but still not working.

any sugestion please

6 REPLIES 6
Rising star

PBR is not working

Did you place the route map on the ingress interface (I assume L3 SVI for 192.168.170.0 network) for the traffic?

interface vlanXX

ip policy route-map MPLS

Beginner

PBR is not working

yes also did this already but still not working.

Rising star

Re: PBR is not working

Did you reboot the switch after you enabled the sdm prefer routing?

It is required when you issue that command.

Participant

PBR is not working

sdm prefer takes effect upon reboot.

Highlighted
Beginner

PBR is not working

no......ok i will reboot the switch and let you know....can you tell me ,,it there any issue that can be create after enabling sdm frefer routing

Participant

PBR is not working

it changes the allocation of TCAM memory. I imagine you should be fine. Ive never had an issue when changing it.

http://www.cisco.com/en/US/products/hw/switches/ps5023/products_tech_note09186a00801e7bb9.shtml

CreatePlease to create content
Content for Community-Ad
July's Community Spotlight Awards