03-15-2013 08:54 AM - edited 03-07-2019 12:16 PM
Dear All,
I have created a PBR in 3650 switch to route traffic from a specific IP address to a specific next hop or IP address(Router)
ROM: Bootstrap program is C3560 boot loader
BOOTLDR: C3560 Boot Loader (C3560-HBOOT-M) Version 12.2(44)SE5, RELEASE SOFTWARE (fc1)
SW1 uptime is 6 weeks, 2 days, 16 minutes
System returned to ROM by power-on
System image file is "flash:/c3560-ipservicesk9-mz.150-1.SE2.bin"
access-list 101 permit ip host 192.168.170.92 10.10.10.0 0.0.0.255
route-map MPLS permit 101
match ip address 101
set ip next-hop 192.168.170.4
The next hop router is connected to this switch directly and member of vlan 170,
I am getting the following error
*Apr 13 23:48:25.104: %PLATFORM_PBR-4-SDM_MISMATCH: PBR requires sdm template routing
I also enable "
sdm prefer routing" but still not working.
any sugestion please
03-15-2013 09:05 AM
Did you place the route map on the ingress interface (I assume L3 SVI for 192.168.170.0 network) for the traffic?
interface vlanXX
ip policy route-map MPLS
03-15-2013 09:15 AM
yes also did this already but still not working.
03-15-2013 09:22 AM
Did you reboot the switch after you enabled the sdm prefer routing?
It is required when you issue that command.
03-15-2013 09:24 AM
sdm prefer takes effect upon reboot.
03-15-2013 09:27 AM
no......ok i will reboot the switch and let you know....can you tell me ,,it there any issue that can be create after enabling sdm frefer routing
03-15-2013 09:33 AM
it changes the allocation of TCAM memory. I imagine you should be fine. Ive never had an issue when changing it.
http://www.cisco.com/en/US/products/hw/switches/ps5023/products_tech_note09186a00801e7bb9.shtml
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide