POST: ILP Controller Tests

[rbreidenstein]

posted below is the output from the post. I then receive an output stating.

!!! WARNING: The switch is not usable !!!

I searched on google and on ciscos site for information even on ILP Controller and nothing comes back.... any suggestions?

The system light is orange.

POST: ILP Controller Tests : End, Status Failed

INIT: failed ILP accessing test

[rbreidenstein]

could it mean In Line Power? but why would that cause the whole switch to fail?

[Amit Singh]

Rick,

That's a Power on Self-Test POST failure. Its related to inline power controller hardware failure. Please go ahead and raise an RMA request, its a hardware failure on the box.

HTH,Please rate if it does.

-amit singh

[karunanithi]

Hi,

Thanks for your help, it really helps, I am facing same issue with my switch.

regards

karuna