ā09-13-2012 04:52 AM - edited ā03-07-2019 08:51 AM
Hi Dear,
I configurated cisco catalyst switch 3750 as stack and then i configurated etherchannel between ESXi 5.0.
this is my etherchannel config:
interface Port-channel1
switchport trunk encapsulation dot1q
switchport mode trunk
switchport nonegotiate
!
interface Port-channel2
switchport trunk encapsulation dot1q
switchport mode trunk
switchport nonegotiate
interface GigabitEthernet1/0/6
description ESX01 Management (on-board)
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 1 mode on
interface GigabitEthernet2/0/6
description ESX01 Management (on-board)
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 1 mode on
interface GigabitEthernet1/0/5
description ESX01 Management (on-board)
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 2 mode on
interface GigabitEthernet2/0/5
description ESX01 Management (on-board)
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 2 mode on
Switch#show etherchannel load-balance
EtherChannel Load-Balancing Configuration:
src-dst-ip
when i wrote show etherchannel summary
it show me all of them are ok. SU and P.
the ping is sometimes is going and sometimes is not.
what is a problem?
i changed mode active, passive the but
the etherchannell is not connected.(down)
please help me. thanks.
ā09-13-2012 05:29 AM
Hi,
Under po1 and 2 do a sh and no sh
than
Can you post "sh etherch summ"?
can you post "sh ether deta"?
Is the SXI server configured as po also?
HTH
ā09-13-2012 05:53 AM
Hi - use "channel-group 2 mode active" to enable LACP. On the ESX configure it as "route based by origional source IP"
Works for us
ā09-13-2012 06:47 AM
Hi,
I suggest you use LACP as the channel protocol for u r ether channels.
I see it is missing in u r config.
Thanks
ā09-13-2012 12:20 PM
Hi,
Please, verify the link's
You need to change "Routed base IP hash" settings,
Regards!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide