Hi Dear,
I configurated cisco catalyst switch 3750 as stack and then i configurated etherchannel between ESXi 5.0.
this is my etherchannel config:
interface Port-channel1
switchport trunk encapsulation dot1q
switchport mode trunk
switchport nonegotiate
!
interface Port-channel2
switchport trunk encapsulation dot1q
switchport mode trunk
switchport nonegotiate
interface GigabitEthernet1/0/6
description ESX01 Management (on-board)
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 1 mode on
interface GigabitEthernet2/0/6
description ESX01 Management (on-board)
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 1 mode on
interface GigabitEthernet1/0/5
description ESX01 Management (on-board)
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 2 mode on
interface GigabitEthernet2/0/5
description ESX01 Management (on-board)
switchport trunk encapsulation dot1q
switchport mode trunk
channel-group 2 mode on
Switch#show etherchannel load-balance
EtherChannel Load-Balancing Configuration:
src-dst-ip
when i wrote show etherchannel summary
it show me all of them are ok. SU and P.
the ping is sometimes is going and sometimes is not.
what is a problem?
i changed mode active, passive the but
the etherchannell is not connected.(down)
please help me. thanks.
