06-12-2013 12:33 AM - edited 03-07-2019 01:50 PM
Hi All,
I'm wondering why i cannot apply qos service-poly into SVI interface if using IOS 12.4T. However, I can apply if i use 12.4 release. I check configuration guide as well as command reference on each version but cannot find this information. Could somebody please share information about this?
12.4T (c2800nm-advipservicesk9-mz.124-15.T10)
12.4 (c2800nm-advipservicesk9-mz.124-16a)
router2811(config-if)#service-policy output app_internal
Configuration failed!
router2811(config-if)#
I configure simple MQC as below
class-map match-all class-Test
match access-group name acl-Test-app
class-map match-all class-Production
match access-group name acl-Production
match not access-group name acl-Test-app
match not access-group name acl-File
policy-map app_internal
class class-Voip
bandwidth percent 10
class class-Test
bandwidth percent 10
class class-File
bandwidth percent 10
class class-Production
bandwidth percent 35
!
06-12-2013 09:15 AM
Rojer,
As per the configuration guide it is supported.
Only issue is:-
Regards
Inayath
06-12-2013 09:46 AM
Hi Inayath,
I got error configuration failed after i try to apply to SVI
06-19-2013 08:52 PM
Look like limitation of Qos on ISR router. It's not software issue.
06-19-2013 10:01 PM
The HWIC in the router supports limited QoS features. If you see the config failed on the later IOS release that is because the parser was updated to reject the config. Older IOS releases would allow it even if it isn't supported. Here is a whitepaper detailing what QoS features you can use.
http://www.cisco.com/en/US/prod/collateral/routers/ps5853/prod_white_paper0900aecd8064c9f4_ps5855_Products_White_Paper.html
HTH,
Dale
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide