cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
356
Views
0
Helpful
1
Replies

QoS in IPSec tunnel over MPLS

Raghavendra Rai
Level 1
Level 1
Dear All, I am planning to configure IPsec Tunnel over MPLS connectivity from the service provider. IPsec tunnel is configured between WAN interfaces of the CPE's at all locations. As per my understanding IPSec encrypts all traffic going inside the tunnel. But I need to configure QoS ,so that in service providers network my data should be prioritized. Is it possible to prioritize traffic inside the tunnel? please suggest.. Thanks, Raghavendra
1 Accepted Solution

Accepted Solutions

Joseph W. Doherty
Hall of Fame
Hall of Fame

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Generally, by default, Cisco tunnel encapsulation will copy the original packet's ToS to the tunnel packet's ToS.  (I.e. all you need to do is insure your original packet's ToS is as desired.)

 

Regarding MPLS vendor QoS support - that's vendor specific - often they offer different QoS models - sometimes they charge for QoS features (i.e. you need to talk with them).

View solution in original post

1 Reply 1

Joseph W. Doherty
Hall of Fame
Hall of Fame

Disclaimer

The Author of this posting offers the information contained within this posting without consideration and with the reader's understanding that there's no implied or expressed suitability or fitness for any purpose. Information provided is for informational purposes only and should not be construed as rendering professional advice of any kind. Usage of this posting's information is solely at reader's own risk.

Liability Disclaimer

In no event shall Author be liable for any damages whatsoever (including, without limitation, damages for loss of use, data or profit) arising out of the use or inability to use the posting's information even if Author has been advised of the possibility of such damage.

Posting

Generally, by default, Cisco tunnel encapsulation will copy the original packet's ToS to the tunnel packet's ToS.  (I.e. all you need to do is insure your original packet's ToS is as desired.)

 

Regarding MPLS vendor QoS support - that's vendor specific - often they offer different QoS models - sometimes they charge for QoS features (i.e. you need to talk with them).

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Review Cisco Networking products for a $25 gift card