cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
762
Views
0
Helpful
1
Replies

Rate Limiting port on Catalyst 3550

gregwoodson
Beginner
Beginner

I am having the same issue as listed in the following case:

https://supportforums.cisco.com/thread/161768

However- even when this is set as an access port- it is not doing rate limiting- should be rate limited to 2Mb (one port traffic goes in- one port traffic goes out- only 2 nodes on the switch).  The relevant config is listed below:

class-map match-all HOC-CAM

match access-group 100

!

!

policy-map CAM-LIMIT

class HOC-CAM

    police 2000000 32000 exceed-action drop

!

!

!

interface FastEthernet0/1

description Connection to HOC Camera

switchport mode access

load-interval 30

service-policy input CAM-LIMIT

!

!

interface FastEthernet0/24

description Uplink to HOC-1611Main-Catalyst

switchport mode dynamic desirable

service-policy input CAM-LIMIT

!

access-list 100 permit ip any any

Any suggestions?

1 Accepted Solution

Accepted Solutions

acampbell
Advocate
Advocate

Hi,

Your config looks OK to me but have you enable qos

!

mls qos

!

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.

View solution in original post

1 Reply 1

acampbell
Advocate
Advocate

Hi,

Your config looks OK to me but have you enable qos

!

mls qos

!

Regards,
Alex.
Please rate useful posts.

Regards, Alex. Please rate useful posts.
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Recognize Your Peers