06-29-2021 10:40 AM - edited 06-29-2021 10:44 AM
3 switches are connected in Ring and by default spanning tree block 1 port.. I have enable REP(RESILIENT ETHERNET PROTOCOL) as I execute command "rep segment 1" on each connected interface, it shows a message that ENABLING REP , disable spanning tree on particular port.. But as I check by "show spanning-tree" command all the REP interface still showing in spanning tree..
Note : I have to disable STP, by enabling REP and Wants to connect switch to switch in Ring and wants port to come up instantly as I connect without going to LRN LSN FWD states .. Please help me in this...
Solved! Go to Solution.
06-29-2021 11:30 AM
what is the device here, show us your config ? where it blocking ?
show rep topology
https://www.cisco.com/c/en/us/support/docs/lan-switching/ethernet/116384-technote-rep-00.html
06-29-2021 11:30 AM
what is the device here, show us your config ? where it blocking ?
show rep topology
https://www.cisco.com/c/en/us/support/docs/lan-switching/ethernet/116384-technote-rep-00.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide