02-17-2023 06:49 PM - edited 02-17-2023 06:50 PM
Hello All,
I have 2 4506-E and the supervisor is WS-X45-SUP7-E with VSS mode, is it possible to upgrade to SUP8-E since SUP7-E is not supported anymore? and this is a hardware revision :
Chasis 1 : Hardware Revision = 1.0
Chasis 2 : Hardware Revision = 1.1
and how to procedure to replacing it ?
Thank you
02-17-2023 10:09 PM
- You may find this thread informational : https://community.cisco.com/t5/switching/replacing-sup-7e-with-sup-8e-on-a-cisco-4510r-e/td-p/3359540
M.
02-18-2023 01:04 AM
what is the version of the IOS code running: you need to look at some support models as below - I need to highlight :
The Cisco Catalyst 4507R-E Switch chassis that has hardware revision 2.0 or higher supports Supervisor Engine 8-E. Before you install Supervisor Engine 8-E on the Catalyst 4507R-E Switch chassis, enter the show idprom chassis privileged EXEC command on the existing switch chassis to know its current revision number.
Note : I am sure you can get refurbished chassis many in the market (when I was looked for us Cat 6500 and Cat 4500 ) - not sure the case now, due to chips shortage, refurbished also expensive.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide