09-04-2018 06:17 PM - edited 03-08-2019 04:04 PM
I need to change my ring topology using rep.
Problem with dhcp in client's ring structure
client has a ring topology
client has a ring topology, when we disconnect one side of the ring the dhcp does not work on some machines.
follows the attached image.
by default it locks a port Gi1/0/2 using rep, it is possible for us to define which port we want to block automatically, eg I want to lock gate gi1 / 0/2 of the LDA-COI-SWC126 switch
Solved! Go to Solution.
09-15-2018 07:09 PM
It's solved, with the commands bellow, in the edge primary port.
interface TenGigabitEthernet1/2
description LDA-SILOS1-SWC134
switchport mode trunk
rep segment 1 edge primary
rep preempt delay 15
rep block port id 00200059DCA1B680 vlan 1-4094
ip dhcp snooping trust
09-05-2018 08:58 AM
09-05-2018 11:23 AM
09-05-2018 11:24 AM
09-05-2018 11:24 AM
09-15-2018 07:09 PM
It's solved, with the commands bellow, in the edge primary port.
interface TenGigabitEthernet1/2
description LDA-SILOS1-SWC134
switchport mode trunk
rep segment 1 edge primary
rep preempt delay 15
rep block port id 00200059DCA1B680 vlan 1-4094
ip dhcp snooping trust
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: