Ring topology problem

[Alexandre11]

need to change the port ALT in my ring topology using rep

 

 

I need to change my ring topology using rep.

Problem with dhcp in client's ring structure

client has a ring topology

client has a ring topology, when we disconnect one side of the ring the dhcp does not work on some machines.

follows the attached image.

by default it locks a port Gi1/0/2 using rep, it is possible for us to define which port we want to block automatically, eg I want to lock gate gi1 / 0/2 of the LDA-COI-SWC126 switch

[Alexandre11]

I need to change my ring topology using rep.

Problem with dhcp in client's ring structure

client has a ring topology

client has a ring topology, when we disconnect one side of the ring the dhcp does not work on some machines.

follows the attached image.

[nazimkha]

Can you post the configs of all the switches.
Which are the edge ports of the REP topology ?

[Alexandre11]

follows the configurations of the attached switches.

Edge Primary - Port T1/2 Switch LDA-4506-GW-TI

Edge Secondary - Port T1/1 Switch LDA-4506-GW-TI

[Alexandre11]

follows the configurations of the attached switches.

[Alexandre11]

follows the configurations of the attached switches.

[AlexandreOppermann · Accepted solution]

It's solved, with the commands bellow, in the edge primary port.

interface TenGigabitEthernet1/2
description LDA-SILOS1-SWC134
switchport mode trunk
rep segment 1 edge primary
rep preempt delay 15
rep block port id 00200059DCA1B680 vlan 1-4094
ip dhcp snooping trust