10-22-2008 03:37 AM - edited 03-06-2019 02:04 AM
Hello Folks!!,
I have a switch with VLAN support and I'd like to segment my LANS with two different VLANs. I'm going to buy two routers cisco, one for each vlans, to give ADLS service. But I want this issue separated. My question is: Do I need to adquire this routers with VLAN support?, or for example with a cisco 857 is enough.
To remember: I don't need routing Ip paquets between VLANs, but I need the VLAN to segment the LANs by security reason.
Thanks in advance!!.
10-22-2008 04:02 AM
From what you defined, your routers don't need to support VLANs. Just connect them to the correct VLAN ports as any other host.
10-30-2008 09:48 AM
Hi Elias,
I dont see why you want to use router , you can use switches to segment it .
Example
(Main SW)
/ \
VLAN1 VLAN2
/ \
/ \
SW1 SW2
Hope this is what you want
HTH
DAK
10-30-2008 10:24 AM
Hi Dave,
I don't need a router to segment it, but I need this one to give ADSL service.
Thanks
10-30-2008 11:21 AM
I would suggest just getting 1 switch and 1 router and run "router on a stick" between the switch and router to provide the layer 3 functionality between the vlans on the switch. Then I would also include an ADSL card for the router.
HTH,
Brandon
10-30-2008 11:24 AM
If you don't need routing between the VLANs for security purposes just setup an ACL between the vlans to restrict traffic.
HTH,
Brandon
10-31-2008 01:21 AM
Ok, you have reason for all. It's the optimum setup, but the problem is that I have hired a VPN by MPLS with my ISP and they don't want that the client operates the router configuration. For this reason, I'm obliged to separete the two ADSL service.
Thanks.
10-31-2008 05:43 AM
In that case put the ACL on the switch you do have control over to filter traffic between vlans.
HTH,
Brandon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide