Routing to ISP using NAT

[BossManUmar]

I have set up multiple vlans which all communicate with each other using a layer 3 switch, the PCs / servers can ping to the router, both the inside and outside port, though for the life of me I can't get it past this point.

I have tried setting up NAT to change the IPs, though I dont think this is the problem.

Fake Company public IP Address: 47.10.21.1 – 47.10.21.14 (Used for NAT i think)

Web server IP address: 77.10.18.50/24

ISP router (fa0/0): 77.10.18.1/24

Any help on this would be appreciated, so I can learn what I am doing wrong, I've followed countess YouTube videos and read through my Cisco command guide so much.

Bare in mind i'm a newbie to all this :) thanks in advance.

[Deepak Kumar · Accepted solution]

HI,

Your NAT was configured wrong. 

below are the correct configuration:

interface FastEthernet0/0
ip address 7.7.10.14 255.255.255.252
ip nat outside
duplex auto
speed auto
!
interface FastEthernet0/1
ip address 10.0.0.1 255.0.0.0
ip nat inside
duplex auto
speed auto

!

!

ip nat inside source list 1 interface fastEthernet 0/0 overload 

Your Fast Ethernet 0/0 is Connects the interface to the outside network.

Don't forget to mark helpful, if it will helpful for you.

Regards,

Deepak Kumar

[BossManUmar]

Hi,

    thank you for the reply, I was able to ping from the router to the ISP, though still unable to ping from the PC to the ISP?

I've updated the file on Google Drive.

Any ideas? 

[Deepak Kumar · Accepted solution]

Please check your NAT ACL also. 

In the Access-list 1, there is only one subnet is allowed as 10.0.0.0/24  but you must allow all subnets which are configured in your LAN or allow all. as 

access-list 1 permit any

Regards,

Deepak Kumar

[BossManUmar]

Life saver!

Thank you very much :))))