04-25-2011 09:07 AM - edited 03-06-2019 04:46 PM
I recently installed 5 SFE2010P switches in stack mode. For the life of me I cannot figure out how to save my running config to my startup config and I've lost my configuration numerous times because of this. Since there isn't a real CLI I can't just do the standard command to save. Documentation is quite laking as well.
Cheers
JJ
04-25-2011 09:30 AM
Welp, think i found this one out
A. Using the web interface, go to the Admin > File Management > Copy Files screen, enable the Copy Configuration option, specify Source File Name as running configuration and Destination File Name as startup configuration. Then, click Apply to procee...
04-25-2011 10:43 AM
This should help
http://belkashop.com.ua/products_files/SFE2010_AG_A_Web.pdf
There is no CLI, but there is a console menu availabel via serial, ssh or telnet. Here you can save configurations, back up confugurations (page 43) and so on.
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide