Setup 9300 Switch

[scoutt]

setting up a new 9300 and loaded it up and went through all the setup questions, not one asked me to assign an IP to the switch, I also can't find anything on the net that shows me how. I don't want to use DHCP, I can login with CLI so I know its all up. The normal

switch# ip address <ip> <subnet> doesn't work on this switch

Thoughts? and thank you

[balaji.bandi]

This switch, so you need to configure the interface to assign IP address.

By Default all the ports are in VLAN 1, if you like to configure vlan1

config t

! 

interface vlan 1

ip address x.x.x.x 255.255.255.0

no shutdown

!

[scoutt]

interesting, that's what I had at one point, but using vlan2 instead, and I couldn't SSH to it or ping it. I'll try again. Come to think of it, I might know what I did wrong. lol

[balaji.bandi · Accepted solution]

you can change what ever vlan number you like, but if you change vlan2 then you need your access port belong to same vlan.

[scoutt]

lol, missed the obvious first time around.

Thank you