SFP Module for Long Distance
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2008 08:54 AM - edited 03-05-2019 09:07 PM
Hi everybody,
i have a doubt, can i use a SFP GLC-LH-SM to MMF (Multi Mode Fiber) ??
Regards,
Hugo
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2008 10:10 AM
Yes, but there are some limitations. Please refer to Table 6 in the following document.
http://cisco.com/en/US/products/hw/routers/ps341/prod_module_installation_guide09186a00801cc731.html
HTH
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2008 10:21 AM
We did happen upon an issue where using the LX/LH moudules over 50um MMF over distances around 200m-250m where we discovered DMD (Differential Mode delay) and had to use relatively costly mode-conditioning patch cables to confirm the condition.
The symptoms that led to this discovery were fairly limited to "input errors" on both end of some trunk links. We're talking about 1 to 2 errors a week. In our case we just went to SX modules and all issues cleared.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2008 10:24 AM
Our interfaces never came up and we too had to use conditioning cables.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-13-2008 01:21 PM
thanks for the information, i'll check it.
regards,
Hugo
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-14-2008 10:17 AM
Hi,
i found next link about GLC-LH-SM SFP where it show this module to both MMF and SMF:
Regards,
Hugo
