SG112-24 Ports

[JimHanus35104]

I'm totally new to networking. I've just replaced a D-Link switch with a Cisco SG112-24 unmanaged switch, and I can't find detailed instructions for it. Specs say ports are 22 x 10/100/1000 + 2 x combo SFP. This switch is just used for basic networking ( PC's, some printers and a router). Should the router be plugged into the combo SFP port, or does it matter which of the 22 ports the router in plugged into? Any info is greatly appreciated!

[balaji.bandi]

here is quick setup guide :

https://www.cisco.com/c/dam/en/us/td/docs/switches/lan/csbus/110_Series/EN/110_Series_QSG-En.pdf

[JimHanus35104]

My port layout is different than the diagram shown on page 12. I'm assuming the world logo means internet?

[balaji.bandi]

yes for uplink.

[JimHanus35104 · Accepted solution]

OK, I will try it. Thanks.

[JimHanus35104]

Does the SFP port require an adapter to use an RJ45? The only contacts are deep inside the port on my switch. My switch does not have 2 sets of ports at the right end as shown in the Unmanaged Switches Guide you sent, just the 2 SFP ports.