04-09-2022 03:56 AM
SG35010P
The system LED keeps blinking green and all ports are down.
From time to time the system LED stops blinking and ports are up and running for a minute or so.
Then the system LED starts blinking again and all ports are down again.
Reset has been useless.
04-09-2022 04:38 AM
Do the quick setup :
04-09-2022 09:20 AM
All done. Nothing changed. The stubburn LED still blinks green and the ports remain desperately down.
04-09-2022 04:50 AM
Hello,
do you have any console output ? Can you access the switch through the GUI ? And if so, which IP address are you using ?
04-09-2022 08:44 AM
Hello,
I have no console output.
I have only a few seconds to log on with the GUI and what I have seen is the following :
IPv6 address renewed by DHCP is fe80:8e19:b5ff:fe0b:65e0
04-09-2022 09:25 AM
I am using DHCP and IPv4 address is 1.192.198.1.10.
Switch responds to ping when LED doesn't blink. That is only during a couple of minutes per hour by slices of seconds. Otherwise no answer.
04-09-2022 09:29 AM
Sorry I meant 192.168.1.10
04-09-2022 01:39 PM
its connected to what device to get ip address, connect console and check.
04-11-2022 01:05 AM
It is connected to DHCP server which is ok
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide