Sg500 / sg500x questions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-26-2018 05:53 AM - edited 03-08-2019 02:01 PM
Dear All,
I would like to ask about sg500, i can see in the document the following:
SG500-52 |
48GE + 4 GE (5G Stacking) |
48 GE |
2 combo GE + 2 1G/5G SFP |
In this picture I can see the 48 port. The 49/S1 and 50/S2 left to the middle sfp-s are the two combo port. I can use the GB eth or the sfp which is next to it (but not the both at the same time). And there are two sfp-s (51/S3 and 52/S4 1G/5G), and leds.
-Can I use the 51/52 ports independently from 49/50?
-Or is it only for 5GB stacking, when I use the 49 and 51 at the same time to stack to another switch?
Could you please help me to clarify it?
Thank you
ports
- Labels:
-
Other Switching
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-26-2018 06:53 AM
-Can I use the 51/52 ports independently from 49/50?
Yes
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-26-2018 07:41 AM
Thank you for your answer. One more question. It seems obvious but please confirm it. Each sfp ports are 1G/5G..
So you don't have to use 2 sfp and something like link aggregation to use 5GB uplink. Just one 5GB sfp modul per sg500 or one 10G fiber sfp modul on SG500X
Is it true?
Thank you
