sg500x vlan & lacp setup

[kevanh]

unable to find any concrete info on taking 2 ports assigning a vlan to then & joining them together via lacp

does not like the vlan - have seen command line instances but not for this switch - any assistance appreciated

[balaji.bandi]

I have noticed some people having issue with SG500X and 500 is ok as per the inputs. i am not a great user of SG models

try to help you with below and technically it should work : (make sure you bind the correct VLAN association)

https://www.petenetlive.com/KB/Article/0001277

Good thread :

https://community.cisco.com/t5/small-business-switches/sg500x-lacp-not-working/m-p/2597462

[kevanh]

i am unable to find the last step where the vlans are assigned to the lag not the ports

re: At this point you need to add your LAG interface into the appropriate VLAN, or more likely set it as a Trunk.

[balaji.bandi]

may be this screenshot help you :