show env all on 3750 switch - Can I change celsius to fahrenheit?

[joshua.gertig]

Hello,

Can anyone tell me if it's possible to change the sh env all output to read temperature in Fahrenheit rather than Celsius?

Thanks!

Josh

[Reza Sharifi]

Hi,

I don't think that is possible.

Also on the 3750, does it actually show the numbers? because on a 3850 it does not.  It just show that the temperature is ok.

xxxxx#sh environment all
Switch 1 FAN 1 is OK
Switch 1 FAN 2 is OK
Switch 1 FAN 3 is OK
FAN PS-1 is OK
FAN PS-2 is OK
Switch 1: SYSTEM TEMPERATURE is OK
SW  PID                 Serial#     Status           Sys Pwr  PoE Pwr  Watts
--  ------------------  ----------  ---------------  -------  -------  -----
1A  PWR-C1-350WAC       xxxxxx  OK              Good     Good     350
1B  PWR-C1-350WAC       xxxxxx  OK              Good     Good     350

xxxxx#

HTH

[joshua.gertig]

Not sure about the 3850 but on the 3750 I use the same command and get temperature:

NRUCFC-S3#sh env all
FAN 1 is OK
FAN 2 is OK
FAN PS-1 is OK
FAN PS-2 is OK
SYSTEM TEMPERATURE is OK
System Temperature Value: 29 Degree Celsius
System Temperature State: GREEN
Yellow Threshold : 46 Degree Celsius
Red Threshold    : 60 Degree Celsius
SW  PID                 Serial#     Status           Sys Pwr  PoE Pwr  Watts
---  ------------------  ----------  ---------------  -------  -------  -----
1A  C3KX-PWR-1100WAC    LIT15200DC1 OK              Good     Good     1100/0
1B  C3KX-PWR-1100WAC    LIT15200DDJ OK              Good     Good     1100/0
2A  C3KX-PWR-1100WAC    LIT15200DBW OK              Good     Good     1100/0
2B  C3KX-PWR-1100WAC    LIT15170J0R OK              Good     Good     1100/0
3A  C3KX-PWR-1100WAC    LIT15170HYS OK              Good     Good     1100/0
3B  C3KX-PWR-1100WAC    LIT15200DH5 OK              Good     Good     1100/0
4A  C3KX-PWR-1100WAC    LIT15200DKF OK              Good     Good     1100/0
4B  C3KX-PWR-1100WAC    LIT15200DKG OK              Good     Good     1100/0