Hey , I'm new here so I sorry if the question doesnt belong to here.
So , I got a couple of cisco 2960-L switches monitoring with portnox with SNMPv2 , so far so good,
My boss came to me and ask me to implement SNMPv3 , so I did all the snmpv3 configuration and for the beginning I configure the OID just ISO.
the problem start with the portnox , the portnox recognize the switch but not the interfaces.
i think my problem is that i need a another OID value for the portnox , but I dont know what value should i use for that.
the portnox support SNMPv3 , and the portnox need to monitor on the interface's things like:
vlan,mac address,ip,state(up/down),ios(of the computer),name of the computer.
so there is someone who use portnox with snmpv3 or know what should OID value should i use for make that thing happen ?
