cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
567
Views
0
Helpful
3
Replies

Stackwise 9500 lost configuration

cmparish5
Level 1
Level 1

We have a pair of Cisco 9500's utilizing stackwise.  We recently lost connectivity to one of the pair and when consoling into it I see it just says Switch# .  I'm new to Stackwise, to reconfig do I just need to power cycle it and the active supervisor to resynch and let the active reconfig the standby?

3 Replies 3

Reza Sharifi
Hall of Fame
Hall of Fame

The switch that lost connectivity is a member switch or the master? if member, can you logon to master and issue "sh switch"?

Also, can you explain  what you mean when you say "We recently lost connectivity to one of the pair" Did you lose management access to the switch?

HTH

balaji.bandi
Hall of Fame
Hall of Fame

If they configured StackWise-Virtual and save config. if one lost power other one should automatically become active.

 

but if you lost connection like SVL and Dual Active, both should become active Active.

 

Console to both and observer show switch and see what status they are  ?

 

post output of both : show switch

show stackwise-virtual

 

BB

***** Rate All Helpful Responses *****

How to Ask The Cisco Community for Help

Leo Laohoo
Hall of Fame
Hall of Fame
What firmware are you using?
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Innovations in Cisco Full Stack Observability - A new webinar from Cisco