Hi,
I have configured my switch port gi0/1 with following config but when I run stp command it shows me port type p2p instead of p2p Edge
Goble commands
spanning-tree mode pvst
spanning-tree extend system-id
interface GigabitEthernet0/1
switchport access vlan 5
switchport mode access
spanning-tree portfast
interface GigabitEthernet0/8
switchport access vlan 5
spanning-tree portfast
Interface Role Sts Cost Prio.Nbr Type
------------------- ---- --- --------- -------- ------------------------
Gi0/1 Desg FWD 5 128.1 P2p
Gi0/8 Desg FWD 5 128.8 P2p Edge
Please Help me what is wrong with it.
Thanks
Nomi