02-24-2009 09:59 PM - edited 03-06-2019 04:13 AM
Hi,
I am having a SUP1A-2GE card installed on a 6509 chassis with 2 no of 3000 Watts Power Supply, but when i power it on, The Sup comes up but the Power Management Led starts to glow in Red and the other Modules WS-X6248-RJ-45 are not powering on.
I have attached the logs of the same.
Kindly help on this
02-25-2009 01:49 AM
Hello Ravi,
it looks like the module are not recognized or supported by this supervisor
see
Console> (enable) show module Mod Model Sub Status
--- ---- ----- ------------------------- ------------------- --- --------
1 1 2 1000BaseX Supervisor WS-X6K-SUP1A-2GE yes ok
15 1 1 Multilayer Switch Feature WS-F6K-MSFC no ok
3 3 Unknown Card power-deny
4 4 Unknown Card power-deny
5 5 Unknown Card power-deny
9 9 Unknown Card power-deny
Hope to help
Giuseppe
02-27-2009 07:20 AM
That's right.
You need to upgrade your sup.
02-27-2009 03:50 PM
WS-X6248-RJ-45 is for the Sup2 engine (hence the "2" in the WS-Xn2nn-RJ-45). Is this a new purchase? If so, please contact your auhtorized Cisco reseller/vendor and see if you can come to an exchange agreement.
Hope this helps.
02-28-2009 11:13 AM
It's not necessary to upgrade your supervisor to get this up and running. The problem is that the WS-CAC-3000W Power supply is not supported in 6.x CatOS software. The minimum CatOS to run this power supply is 7.5(1).
Your supervisor only has 64MB of DRAM, so while you can upgrade to 7.5(1), you can't go much higher than that. Check the DRAM requirements in the same document:
http://www.cisco.com/en/US/docs/switches/lan/catalyst6500/catos/7.x/release/notes/OL_1982.html
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide