Hi All,
I have a Sup 720-3b in a Cisco 6509E chassis , that also only boots up into Rommon mode, but when issue with the " boot "command it will find the IOS from the bootdisk and try to boot. The boot process will only get to the point where the Switch Processor ( SP ) needs to hand over to the Route Processor ( RP ) and fail and reboots to rommon.
I have check the " set "vairables and below is a copy of it. When I try and make changes to specify the IOS on the bootdisk specifically it doesn't seems to take this changes, even if i do a sync afterwards.
rommon 1 > set
PS1=rommon ! >
LOG_PREFIX_VERSION=1
SLOTCACHE=cards;
BOOT=bootdisk:,1;
ACL_DENY=0
BSI=0
CRASHINFO=crashinfo_FAILED
RET_2_RTS=02:29:39 UTC Thu Nov 26 2009
RET_2_RCALTS=1259202581
?=0
PF_REDUN_CRASH_COUNT=0
When I issue the command "confreg 0x2102 " it still gets to the same point where the ( SP ) needs to hand over to the ( RP ) and fail, but I do get some useful info displayed on the console, but not sure how I would be able to fix my problem as I don't seems to be able to change the boot vairables.
Here is the output from the console.
System Bootstrap, Version 8.4(2) Release
Copyright (c) 1994-2005 by cisco Systems, Inc.
Cat6k-Sup720/SP processor with 524288 Kbytes of main memory
Autoboot executing command: "boot bootdisk:"
Initializing ATA monitor library...
string is bootdisk:s72033-ipservices_wan-vz.122-18.SXF11.bin
Loading image, please wait ...
Initializing ATA monitor library...
Self extracting the image... [OK]
Self decompressing the image : ############################################################################################################################################################################################################################### [OK]
running startup....
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) s72033_sp Software (s72033_sp-IPSERVICES_WAN-VM), Version 12.2(18)SXF11, RELEASE SOFTWARE (fc1)
Technical Support: http://www.cisco.com/techsupport
Copyright (c) 1986-2007 by cisco Systems, Inc.
Compiled Fri 14-Sep-07 23:25 by kellythw
Image text-base: 0x01020150, data-base: 0x01021000
Created ION FileSystem for disk0, disk1
Active crashed three times, disabling auto-boot and dropping to rommon
Crashdump : 04:25:55.936 Tue Feb 9 2010 : ios-base : (PID=12312, TID=4) : -Traceback=(s72033-ipservices_wan-9-dso-b.so+0x5D8D0) ([32:0]+0x61F74) ([32:0]+0x4C064) ([32:0]+0x46E70) ([22:-9]4+0x13DE4) ([32:0]+0x13DBC)
crashdump called (with pause = 0 sec)
Buffered messages:
Queued messages:
%ALIGN-1-FATAL: Illegal access to a low address
addr=0x0, pc=0x73E88728, ra=0x73E88724, sp=0x2CBDE68
SLOT0:00:00:31: %DUMPER-3-PROCINFO: pid = 12312: (sbin/ios-base), terminated due to signal SIGSEGV, Segmentation violation (Address not mapped)
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: zero at v0 v1
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: R0 00000000 793F5698 00000000 00000000
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: a0 a1 a2 a3
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: R4 0205CB44 797253D4 000079D8 00000000
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: t0 t1 t2 t3
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: R8 00000000 00000000 00000053 00000020
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: t4 t5 t6 t7
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: R12 00000000 FFFFFFE0 FFFFFFFF 73512000
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: s0 s1 s2 s3
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: R16 02CBE128 02CBE158 00000000 00000000
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: s4 s5 s6 s7
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: R20 00000000 00000000 00000000 00000000
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: t8 t9 k0 k1
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: R24 02CBDD68 732CABB4 00000000 00000000
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: gp sp s8 ra
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: R28 7A570D50 02CBDE68 00000000 73E88724
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: sr lo hi bad
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: R32 1000FC63 00000000 00000001 00000000
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: cause pc epc
SLOT0:00:00:31: %DUMPER-3-REGISTERS_INFO: 12312: R36 0080000C 73E88728 00000000
SLOT0:00:00:31: %DUMPER-3-TRACE_BACK_INFO: 12312: (s72033-ipservices_wan-7-dso-b.so+0x43F728) (s72033-ipservices_wan-9-dso-b.so+0x5D8D0) (s72033-ipservices_wan-9-dso-b.so+0x61F74) (s72033-ipservices_wan-9-dso-b.so+0x4C064) (s72033-ipservices_wan-9-dso-b.so+0x46E70) (s72033-ipservices_wan-4-dso-b.so+0x13DE4) (s72033-ipservices_wan-4-dso-b.so+0x13DBC)
SLOT0:00:00:34: %DUMPER-6-BAD_PATH: 12312: Choice 1 either not configured or bad path. Trying next choice.
SLOT0:00:00:34: %DUMPER-6-BAD_PATH: 12312: Choice 2 either not configured or bad path. Trying next choice.
SLOT0:00:00:34: %DUMPER-6-BAD_PATH: 12312: Choice 3 either not configured or bad path. Trying next choice.
SLOT0:00:00:35: %DUMPER-3-DUMP_FAILURE: 12312: Core dump failed: Could not create core
SLOT0:00:00:35: %DUMPER-3-CRASHINFO_FILE_NAME: 12312: Crashinfo for process sbin/ios-base at bootflash:/crashinfo_ios-base-20100209-042556
SLOT0:00:00:35: %SYSMGR-3-ABNORMTERM: ios-base:1 (jid 73) abnormally terminated, restart disabled
SLOT0:00:00:35: %SYSMGR-6-ERROR_EOK: ios-base:1 (jid 73) mandatory process exited, rebooting
System Bootstrap, Version 8.4(2) Release
Copyright (c) 1994-2005 by cisco Systems, Inc.
Cat6k-Sup720/SP processor with 524288 Kbytes of main memory
Any ideas would be welcome as I am really desperate to get this issue sorted so that I can deploy this device.
Cheers,
