Hello,
Have a couple of 9500 Distribution Switch. For any 9300 access switch, there is a 25 Gig Uplink which goes from each distribution switch to the 9300 3nos-Switch stack. Does this mean the total bandwidth is 50Gig
Below is the config I see on one of the 9300. I can see traffic on both interfaces. But not sure if the combined bandwidth is 50Gig.
interface TwentyFiveGigE1/1/1
description Fabric Physical Link
no switchport
dampening
ip address 10.0.XX.XX 255.255.255.254
no ip redirects
ip lisp source-locator Loopback0
ip pim sparse-mode
ip router isis
load-interval 30
speed 25000
bfd interval 100 min_rx 100 multiplier 3
clns mtu 1400
isis network point-to-point
end
!
sh run in Twe2/1/1
Building configuration...
Current configuration : 275 bytes
!
interface TwentyFiveGigE2/1/1
no switchport
dampening
ip address 10.0.XX.XX 255.255.255.252
no ip redirects
ip pim sparse-mode
ip router isis
load-interval 30
speed 25000
bfd interval 100 min_rx 100 multiplier 3
clns mtu 1400
isis network point-to-point
end
Thanks